HBI Ruger SFAR Gas Regulator | 5 Position

Description

We are proud to offer a wide range 5-position gas regulator for the Ruger SFAR family of rifles. Our Gas Regulators are direct drop in replacements for the factory regulator and have been carefully tuned and optimized to provide absolute reliability and consistent ejection in each specific caliber and barrel length. The 5 gas positions in each regulator allow you to dial in your specific rifle for any ammo/suppressor/muzzle device/altitude/temperature by simply rotating the regulator between positive detents, just like the factory part. Compared to the factory parts, our regulators have finer resolution between settings, with additional low end gas settings to accommodate a much wider range of suppressor pressures. Our regulators are machined in house from chromoly steel, heat treated, and finished in black nitride.

Please use the drop down menus above to select your specific caliber and barrel length. If your SFAR has been modified with a barrel length not listed please contact us directly and we can help you select the best regulator for your specific configuration.

NOTE: Ruger recommends a 100-200rd “break in” period on all SFAR rifles. While we have found this to be excessive in many cases, there is commonly *some* break in required to get the bolt and barrel extension running smoothly. On brand new rifles we typically recommend running gas fully open for a few mags before trying to fine tune.

• Optimized 5 Position Gas System for the Ruger SFAR
• Tuned for Specific Calibers and Barrel Lengths
• Drop In for all .308 and 6.5CM Models
• Ideal for Suppressed Rifles
• Regulator can be Rotated by Hand, with 3/16 Allen Key, or a Bullet Tip
• Machined from Chromoly Steel and Black Nitride Finished

Designed and Manufactured completely in USA.

Gunsmith Installation Recommended for All Parts.