Description
This Grip Panel is designed to replace the picatinny/1913 rail section on one or both sides of your B&T APC 9/45/223/300. Our Slim Grip Panels are 3.4mm thick (B&T picatinny rail is 7mm thick) and are profiled to provide great traction in the center before blending out along the edges back into the APC upper receiver. We incorporated the straight slot/rib geometry used on the APC grip and lower receiver to help give this replacement panel a factory look.
Our grip panel is machined from 6061-T6 aluminum and hard anodized black per MIL-A-8625. Installation is achieved by removing the 2mm hex/allen or Torx T10 screws in your factory rail section (depending on model), replacing that rail section with our Slim Grip Panel, and then re-installing the factory screws. These Slim Grip Panels DO fit the B&T GHM9, however they are physically taller than the factory picatinny rails and do partially block the cooling vents along the top of the GHM9 forend.
Please note that these grip panels are sold individually so that they can be mixed/matched/paired with light mounts or other accessories. If you wish to delete the picatinny rail on one (1) side of your APC please order quantity one (1). If you wish to delete both the left and right picatiny rails on the sides of your APC please order quantity two (2).
NOTE: These panels are NOT compatible with MLok type B&T handguards/foreends. They are designed specifically to replace the B&T 2-screw type panels.
- Slim Forend Grip Panel for B&T APC9/45/223/300
- Replaces Factory Picatinny Rail Section
- Just 3.4mm Thick, Half Thickness of Factory Pic Rail
- Machined Aluminum 6061-T6
- Hard Anodized Black Per MIL-A-8625
Designed and Manufactured completely in USA.
Gunsmith Installation Recommended for All Parts.
Binh Le (verified owner) –
These are asthetically pleasing and look right at home on the APC 223. I just wish the finish was more factory like.
P (verified owner) –
Looks and feels awesome on my APC9
Matthew (verified owner) –
Great way to cover the holes around the M-Lok.
Robert Conner (verified owner) –
These are great on my APC45. The machining is high quality and they look stock. If you don’t need a linear mile of rail on your APC, these give a functional slim grip, and present a bit of an ‘old school’ look and feel.